To Next PageTo Next Page
Need help?Do you have a question about the Trevi 178 and is the answer not in the manual?
General| Pool type | Above ground |
|---|---|
| Shape | Round |
| Material | Steel |
| Installation Type | Above ground |
| Included Accessories | Ladder |
Measure and mark the pool site using stakes and half circles.
Dig 15cm trenches and clear grass from the outlined area.
Ensure the ground surface is level and free of debris for pool installation.
Dig trenches for buttress assemblies to the required depth and thickness.
Dig a hole for the drain and a trench for the hose to the motor.
Install the drain, connect the hose, and secure it with glue and collars.
Join splice brackets to the foot beam with bolts, nuts, and spacers.
Attach buttress posts to foot beams using bolts, spacers, and washers.
Cover bolt heads and insert styrofoam blocks at foot beam ends.
Consult chart for correct number of tension straps per pool size.
Assemble metallic tension straps and attach to foot beams.
Add sand, select filter location, and prepare wall pre-punched holes.
Insert wall into bottom tracks and join ends, ensuring alignment.
Spread and level approximately 10 cm of compacting sand for the pool base.
Insert vacuum cleaner hose and block skimmer hole to prevent air leaks.
Unfold liner, hang over wall, secure with couplers and top track.
Install the pump return fitting after removing the vacuum cleaner.
Secure uprights to the bottom plate and bottom track notches.
Place and center the top seat on uprights, securing with screws.
Slide lens into cap extension and attach to upright with screws.
Snap seat cap onto seats and cap extension, securing with screws.
Pass sensor wire, connect wires, and place battery case in housing.
Install safety labels both inside and outside the pool per instructions.
Assemble skimmer, inlet, drain, filter, pumps, and hoses.
Confirm quantities of all pool parts and accessories against the list.
