OPTIONAL LIGHTING
15
SECURITY LABELS INSTALLATION
16
Optional lighting: Pass the sensor wire through the hole on top of
the seat cap and hold it in place with the plastic frame.
Connect the two wires together and place the battery case in the
lens housing. Install all in the cap extension.
Install the four (4) safety labels (DANGER) supplied with your pool
as follows: two (2) labels visible at the entrance to the pool and two
(2) visible at the main access of the backyard.
Important: if you require additional labels, please contact us at
Trevipools.com
Install a minimum of three (3) safety labels (supplied with the liner)
inside the pool so that at least one label is visible no matter where
the bather enters the water (see drawing for positionning)
To Next Page
Loading...
