Page15
HONING DISC REPLACEMENT
When a new or resurfaced honing disc is installed on machine the following
adjustments must be verified before machine can be used (this is not required if
turning disc over to use other side). This is due to variations in thickness of honing
discs.
Adjustment of arms parallel to honing disc
The cutter and comb holder arms must be set parallel to the surface of the honing
disc that is on machine (thickness of honing disc changes when resurfaced).
Mount size 10 or 15 comb blade on holder.
Mount cutter on cutter holder.
With disc turned off lower arms to surface of honing disc.
Loosen screws on side of machine this will allow you to raise or lower automatic
assembly and set arms parallel to honing disc.
Screwforadjustingarmsparallelwithhoningdisc,oneoneachsideofmachine
Plasticscrewcovercapsinarmrests
To Next Page
Loading...