Page 7
CHARGING HONING DISC
STEP 1
Atomizer spray bottle comes already filled with honing oil, you must pressurize the
bottle with air. This can be done the same as filling a car tire with air or use a
bicycle tire pump. Fill to 50 – 90 pounds air pressure.
Add honing powder into supplied powder dispenser (salt shaker).
STEP 2
Before using a new or resurfaced honing disc you must first do an initial charging
of honing oil and honing powder. Machine is shipped on low speed setting please
leave it on low speed for the initial charging.
1. Spin honing disc by hand.
2. Hold atomizer 8 to 10 inches above disc.
3. Apply a fine spray of honing oil on disc by a 1-2 second burst from atomizer,
honing oil should fall on honing disc as shown below as disc is slowly
revolving.
Fine mist of oil to fall
on disc in this area as
disc s
ins slowl
.
To Next Page
Loading...