INSTALLATION INSTRUCTION
This appliance must be installed to current gas regulations set out by Corgi and must be only Installed by
Corgi Registered (in Commercial Catering equipment) Engineers - failure to do so will render the
installer liable to prosecution and invalidate all warranties.
Siting of appliance:
The appliance must be installed in a well ventilated area, under an extraction canopy that conforms to
current regulations. Adequate supply of fresh air is required to allow proper combustion. (inadequate air
will result in poor performance of appliance and will Invalidate the warranty).
Minimum c1earnaces from combustible walls
Back 100mm (4 inches)
Sides 305mm (12 inches)
Minimum clearances from non combustible walls
Back 0mm (0 inches)
Sides 0mm (0 inches)
This appliance should only be fitted on a level floor of a non combustible, heat resistant fireproof
material.
This appliance must be Levelled using a Spirit level.
4
Gas Connection
FIGURE A:
To Next Page
Loading...