EasyManua.ls Logo

Trianco Activair - SAFETY PRECAUTIONS; Cautionary Statements

Trianco Activair
33 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
Do not place a heater or other appliances near the power cable.
Risk of fire or an electric shock.
Be cautious that water could not be poured into the product directly, do not allow water to run into electric parts.
Risk of fire or an electric shock.
If the supply cable is damaged, it must be replaced by qualified person to avoid a hazard.
This appliance has not been designed for use by persons (including children) with reduced physical, sensorial, or
mental faculties or by persons without any experience or knowledge of heating systems, unless they act under the
safety and supervision of a responsible person or have received prior training concerning the use of the appliance.
Children should be supervised to ensure that they do not play with the appliance.
IF THE PRODUCT IS NOT TO BE USED FOR AN EXTENDED PERIOD OF TIME, WE STRONGLY RECOMMEND NOT
TO SWITCH ‘OFF’ THE POWER SUPPLY OF THE UNIT.
IF THE POWER IS NOT SUPPLIED, THE ANTI-FREEZE FUNCTION WILL NOT BE PERFORMED.
Do not install the unit in a place where there is a chance of flammable gas leaks.
If there is a gas leak and gas accumulates in the area surrounding the unit, it could cause an explosion.
Perform the drainage/piping work according to the installation instruction.
Do not clean the unit when the power is on.
Always shut off’ the power when cleaning or servicing the unit. If not, it could cause an injury due to the high-speed
running fan or an electrical shock.
Do not continue to run the unit when there is a suspected fault.
The power supply needs to be shut ‘off’ to stop the unit; otherwise, this may cause an electrical shock or fire.
Be cautious when unpacking and installing the product.
Sharp edges could cause injury. Especially watch the edges and the fins on the heat exchanger of the product.
Always check for gas (refrigerant) leakage after installation or repair of product.
Low refrigerant levels may cause failure of the product.
Keep level even when installing the product.
This is to avoid vibration or water leakage.
Do not place hands or fingers into the fan, or evaporator.
The ventilator runs at high speed, this could cause significant injury.
Keep the unit upright, even when transporting and installing the product.