4
IMPORTANT PRE-INSTALLATION NOTES
Before installation, it is imperative that the following guidelines are heeded to ensure the trouble-free and efficient operation of
the boiler:
Siting
The water heater should not be installed in a shower compartment or bathroom.
When siting the boiler, consider the potential requirement for future access to the cold-water inlet. The supplied in line filter
should be cleaned either on an annual basis or when a reduction in water flow is noticed.
The cold supply should have an isolation valve close to the appliance.
Power Supply and Wiring
The power supply to the premises must meet the minimum requirements of the unit being installed, with special attention paid
to the supply current, cable size, and RCD recommendation. The supply voltage to the appliance must never drop below 207
Volts.
To keep the casing clean, switch ‘OFF’ the water heater at the electrical supply, and simply wipe with a damp cloth. DO NOT use
abrasive cleaning fluids as this may damage the stove enamel paintwork.
TR ENGINEERING LTD CUSTOMER AFTER SALES SERVICE INFORMATION
What to do in the event of an appliance fault or breakdown:
Step 1: Always contact your installer in the first instance, who must thoroughly check all his work PRIOR to contacting TR
Engineering LTD.
Step 2: If your appliance has developed an in-warranty fault your installer should contact TR Engineering LTD for assistance
from site.
We offer a Return-to-Base Warranty, please contact the service department for more details.
PLEASE NOTE: UNAUTHORISED INVOICES FOR ATTENDANCE AND REPAIR WORK CARRIED OUT ON THIS APPLIANCE BY ANY
THIRD PARTY WILL NOT BE ACCEPTED BY TR ENGINEERING LTD
SERVICE CENTRE AND TECHNICAL SUPPORT
Tel: 0114 257 2300 Fax: 0114 257 1419
Hours of Business
Monday to Thursday 8.30am - 5pm
Friday 8.30am - 2.30pm
To Next Page
Loading...