Tribe PASS - Page 6

Trïbe Technologie – PASS Manual Page 6
Internal & back connection
IN 1: Receives the signal from ACTIVE OUT (Back). Sends the signal to the next loop.
Connecting a cable into this input deactivates the signal received from ACTIVE OUT
(Back).
SEND / RTRN (Return): Looping made by a gas-sealed gold contact relay. When the
loop is activated, the signal is output through SEND and is sent to the device connected
to it, and returns through the input RTRN, then is sent to the next loop or OUT.
OUT 1: Receives the signal from the last loop. Sends the signal internally to the next IN.
Connecting a cable into this output deactivates the signal sent to the next IN.
This process is the same for the 5 other loop sections. Here are some clarifications:
- OUT 1 internally sends the signal to the IN 2. Connecting a cable to one of
those connectors deactivates the internal signal.
- OUT 2 internally sends the signal to the IN 3. Connecting a cable to one of
those connectors deactivates the internal signal.
- OUT 3 internally sends the signal to the IN 4. Connecting a cable to one of
those connectors deactivates the internal signal.
- OUT 4 internally sends the signal to the IN 5. Connecting a cable to one of
those connectors deactivates the internal signal.
- OUT 5 internally sends the signal to the IN 6. Connecting a cable to one of
those connectors deactivates the internal signal.
- Out 6 is the signal’s final output, there is no internal connection after this
output.
(See appendix section for more examples)