Trïbe Technologie – PASS Manual Page 11
Operating the unit
Insert the SD card into the SD CARD slot, and then turn on the power with the PWR
button. The unit will display «TRIBE TECHNOLOGIE WWW.TRIBEFX.CA», during
this operation; the unit will recover all system information, do not touch anything on the
unit during this operation.
Once the recovery is done, the unit will go to preset 000 and will await a signal.
- Any external Midi controller that can send Program Changes (PC) and Control
Changes (CC) can be used to control this unit.
- If you don’t use an external Midi controller, you can use the internal controller
to change presets by turning the «Edit» knob. This internal controller cannot
be used to control another Midi device.
- Upon receipt of a Program Change (PC) Midi signal on the programmed
channel, the unit will immediately change to the associated preset.
- Upon receipt of a Control Change (CC) Midi signal on the programmed
channel, the unit will change the state (On/Off) of the associated loop. If the
loop is momentary, it will be activated for 0.5 seconds and then deactivated.
- You can change the state (On/Off) of each loop by using the associated button
on the front panel, as if it was a Control Change (CC).
Saving from the unit
When you make a modification to a loop’s state (On/Off) and you want to save this
configuration:
- Push «Edit», an underline will appear under the first character of the preset
name.
- You can cancel the saving operation at any time by pressing the «Cancel»
button.
- OPTIONAL: You can change the preset name. By turning the «Edit» knob,
you can change the underline character. Push the «Edit» knob to go to the next
character. You cannot go back to a previous character, you have to continue
on to each character in order to get back to the one to be modified.
- During this action, LEDs for each activated loop will light up, and the
momentary loop will stay activated.
- To change the state (On/Off) of an additional loop, push the desired loop
button.
- Push «Save» to save the new configuration.
Don’t forget that all new configurations won’t be on your computer, do a
«Backup data from SD card» to transfer the configuration to your computer’s
hard disk.
Fast save summary: If you make a loop state (On/Off) change and want to save it, push
«Edit» and then push «Save».
To Next Page
Loading...