Trïbe Technologie – PASS Manual Page 7
This type of loop is different. It is not internally connected to any loop, and can be used
for different purposes:
- Amplifier signal control: Connect the signal to the IN and connect your
amplifier to the OUT. When the loop is activated, the signal is transmit ted to
the amplifier. When the loop is deactivated, the signal is not sent, and the
amplifier is muted.
- Amplifier channel control: If your amplifier is equipped with channels that
can be controlled by a footswitch, you might be able to control it with this
type of loop. Refer to your amplifier manual for the type of control needed:
Latching or momentary; normally open (N.O.) or normally closed (N.C.).
NEVER TRY TO CONTROL 2 CHANNELS WITH ONE LOOP, YOU
MIGHT DAMMAGE YOUR EQUIPMENT.
- Instrument control: By using inverted loops, you can choose between
multiple instruments. (See appendix for an example)
Midi Connection
Midi IN: Connect your Midi controller into this connector with a Midi cable.
Midi Thru: The signal received from the Midi IN is replicated on this output connector.
Power Connector
Use only an adaptor that outputs 12V DC with a minimum of 1 Amp, positive center, 2.5
mm. Any other type of adaptor can damage your unit, and wouldn’t be covered by the
warranty and would automatically revoke it.
To Next Page
Loading...