Trïbe Technologie – PASS Manual Page 10
On the unit
This section is for modifying the options without the use of the computer or for people
that don’t have access to a computer.
1) Insert the SD card in the unit and then turn on the unit. After the start up, the unit
will calibrate itself to the preset 000.
2) Push the «Menu» button; you are now in the main menu. The cancel button
allows you to exit the main menu without saving. If you turn the «Edit» knob, this
will allow you to choose the parameter you want to edit.
3) Push «Enter» to edit:
- «Midi Channel»: Turn «Edit» knob to choose the channel on which the unit
will receive the Midi signal. 0 = Omni, unit will respond to signals on all Midi
channels (1 @ 16). Push «Menu» button to accept.
- «Loop Modes»: Allows you to choose the mode for each loop between
latching and momentary. Turn the «Edit» knob to choose the loop to
configure, and then push «Enter» for changing the mode. Once all changes are
made, push the «Menu» button to go back to the menu. The momentary mode
functions as follows: Upon receipt of a change of state, the loop will be
activated for 0.5 seconds and then will be in an inactive state until the receipt
of a new change of state.
- «Loop ## CC Message»: Choose the loop to be edited. Push one time on
«Edit» , turn the «Edit» knob to choose the Control Change (CC) number you
want the loop to change state (On/Off) of upon receipt of that Control Change
(CC) number. Once done, push «Menu» to go back to the main menu.
o For each Control Change (CC), the values are:
0-63 : Loop is inactive
64-127: Loop is active, (0.5 second for momentary)
Example: Loop 02, CC #51, value between 0 and 63 = deactivated
Loop 02, CC #51, value between 64 and 127 = activated (0.5
seconds for momentary)
When all changes are made and you come back to the main menu, push «Save» to save
your changes on the SD card. The unit will display «Saving, please Wait», DO NOT
TOUCH ANYTHING ON THE UNIT DURING THIS OPERATION. When the saving
is done, the unit will go back to the preset mode.
All changes made on the SD card from the unit will not be saved on your computer hard
disk. You need to do a «Backup data from SD card» to transfer the new configuration on
your computer.
To Next Page
Loading...