Trïbe Technologie – PASS Manual Page 9
- «Loop modes»: Choose the mode for each loop between latching or
momentary. When it’s done, click «Save loop modes to SD». The momentary
mode work this way: Upon receipt of a change of state, the loop will be
activated for 0.5 seconds and then will be in an inactive state until the receipt
of a new change of state.
- «Loop MIDI CC»: For each loop, choose the Control Change (CC) number
you want the loop to change state.
- «Loop names»: You can name each loop; this will help you when
programming your configuration. The name of each loop will only appear in
the computer program, and doesn’t appear on the unit LCD screen. Once the
naming is done, click «Save loop names» to save; the program will
automatically restart.
- «Settings»:
o «Device MIDI channel»: Choose the channel on which the unit will
receive the Midi signal. 0 = Omni, unit will respond to signals on all Midi
channels (1 @ 16).
o «Backup data from SD card»: Allows you to save all data from your SD
card onto your computer hard disk. New data will erase previous data.
o «Restore data to SD card»: Allows you to save all data from your
computer hard disk onto your SD card. New data will erase previous data.
o «Format SD card»: To be used when you use a new SD card.
If you plan on using several SD cards for different setups, we recommend that you
copy the entire «SD Editor for Windows» folder to the number of setups you have, and
give a different name for each setup.
Example: «SD Editor for Windows Show 1», «SD Editor for Windows Show 2», «SD
Editor for Windows part 1», etc…
Because when you will be doing a backup from your SD card on your hard disk, it will
erase previously saved information. When creating a folder for each setup, you will have
a backup for each setup.
Use the «Trïbe_Technologie.exe» file of each corresponding folder for editing each
corresponding SD card.
To Next Page
Loading...