2.1 Safety notices.
TRIGON ELEKTRONIK assumes no liability for damage, which result from
inappropriate handling and/or disregard for the following safety instructions.
- The CD-player may not be placed close to strong heat sources such as heating
elements, furnaces, high-powered lamps, open fires, etc.
- The CD-player may not be exposed to strong impacts and vibrations.
- The CD-player may not be connected to the power outlet immediate after being brought
from a cold environment to a warm one. Condensation could damage the device.
Wait a few minutes until the device is warmed up to room temperature.
- The CD-player should not be exposed to direct sunlight.
- Please ensure that the device gets sufficient ventilation at its installation location.
- Don’t pour fluid on the CD-player; the inside of the device must remain dry.
- Never activate the device without having the protective casing in place.
- Always remove the power plug from the socket before opening the device.
- Never bridge the fuse. Please replace a defective fuse only with an original fuse
of the same type and rating.
- Never attempt repairs on your own. Only authorized, properly trained technical
personnel may undertake any maintenance and/or repair. Any damage that results
from improper handling or unauthorized repair attempts will void any possible
warranty claim.
- Please always turn off your system’s device before changing and/or attaching cables.
- The Exxceed can operate at a voltage between 180V and 250V, 230V
is the average. If another voltage is required, please contact your dealer or
TRIGON, so that the device can be retrofitted.
To Next Page
Loading...