Trigon EXXCEED - 2.2 Setup Recommendations; 2.3 Guarantees and Service; 3. Initial Setup and Operation

2.2 Set-up Recommendations
After unpacking the unit, examine the device first for possible transport damage. If you
should determine damage has occurred, then immediately contact your dealer. Next,
examine the contents of the container to ensure all components are present. You should
find, addition to the Exxceed, the following:
- Mains cable TRIGON VOLT
- IR remote control DIRECTOR
- Operating instructions Exxceed
- Warranty requirement certificate
Set up the device horizontally in a dry place. Ensure good ventilation. Strong magnetic
scattering fields, which are caused by output stage transformers and halogen light
transformers, can lead to stray humming effects. Therefore set up the CD Player some
distance from such devices. Also, do not lay the cable connections parallel to the lighting
leads.
Stray humming effects are also produced from fluorescent lamps, so keep a minimum
distance of approximately 1m. Avoid direct sunlight and don’t set up the Exxceed close
to strong heat sources.
2.3 Guarantees and Service
The Exxceed is a high-quality and sophisticated product. We at TRIGON try to
ensure the demands made of a TRIGON-product are met via numerous quality tests
and strict goods control. If a problem should however occur, then TRIGON
ELEKTRONIK GmbH grants a 3-years warranty. The warranty includes the repair
of the defective part as well as any labor charges. This is the limit of liability.
The warranty excludes any damage which resulted from inappropriate installation,
incorrect operation or repairs through unauthorized specialist dealers and private
individuals. Further the warranty is void with disguised serial numbers as well as when
damage occurs as a result of accident or transport damages.
3 Commissioning
After unpacking the CD player, we recommend that you first only connect the device to the
mains and switch it on without having connected it to other devices. Turn on the standby
power switch [8] on the back of the device and then touch the [6] ON / OFF button on the
front. The display lighting switches on and after a few seconds the output relays are
switched on.
The EXXCEED is now ready for use.
Now touch the [5] OPEN key. The CD drawer opens and you can insert a CD. Touch the
button [5] again to close the drawer. After the EXXCEED has read the CD information,
the display shows the number of tracks and the total playing time.
5