EasyManuals Logo
Home>Trilithic>Measuring Instruments>360 DSP

Trilithic 360 DSP User Manual

Trilithic 360 DSP
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
360 DSP - Operation Manual, Wi-Fi Option
2
Industry Canada Compliance
This device complies with Industy Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) This device may not cause harmful interference. and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC Part 15 Compliance
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the device and receiver
Connect the device into an output on a circuit different from that to which the receiver is
connected
Consult the dealer or an experienced radio/TV technician for help
Persuant to FCC 15.21 of the FCC rules, changes not expressly
approved by Trilithic might cause harmful interference and void
the FCC authorization to operate this product.
The antenna used for this instrument is installed at the Trilithic
factory or by Trilithic approved repair facilities. During operation
of the device, a distance of 20 cm or more should be maintained
between the antenna in this device and person. To ensure
compliance, do not operate at closer distances than this. The
antenna on the 360 DSP is located inside the device at the top of
the unit attached to the back plastic case. Do not use any
antenna other than the installed antenna.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Trilithic 360 DSP and is the answer not in the manual?

Trilithic 360 DSP Specifications

General IconGeneral
BrandTrilithic
Model360 DSP
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals