To Next Page

To Previous Page

EASyCAST - Installation Manual

Manual and Automatic modes provide control over the re-sending of EAS events when the

station is manned or unmanned. The EASyCAST can be changed from manned (manual) to

unmanned (automatic) mode through the front panel menu system or the configuration software.

Automatic mode: Each EAS event can be configured to be disabled (off - do not send event) or

to send immediately after receipt (send event immediately).

Manual Mode: Each EAS event can be configured to wait indefinitely for permission to send

(never auto-send), to send immediately after receipt (send immediately), or to wait a specified

number of minutes before sending (send in xx minutes). When an EAS event is waiting, an

operator can manually override the delay by either sending the message, or cancelling it. The

configurable time delays are 5, 10, 15, 20, 30, 45, or 60 minutes.

Event

Code

Event Description Enabled

Auto Mode Delay Manual Mode Delay

NIC National Information Center

NMN Network Message Notification

NPT National Periodic Test

NUW Nuclear Power Plant Warning

RHW Radiological Hazard Warning

SMW Special Marine Warning

SPS Special Weather Statement

SPW Shelter in Place Warning

SVA Severe Thunderstorm Watch

SVR Severe Thunderstorm Warning

SVS Severe Weather Statement

TOE 911 Telephone Outage Emergency

TOA Tornado Watch

TOR Tornado Warning

TRA Tropical Storm Watch

TRW Tropical Storm Warning

TSA Tsunami Watch

TSW Tsunami Warning

VOW Volcano Warning

WSA Winter Storm Watch

WSW Winter Storm Warning

Trilithic EASyCAST User Manual

Questions and Answers: