Trimax Snake - Lift Mower and Remove Wheel; Remove Bearing Buddy or Grease Cap

2
Position the Guards as shown with the
LONG side of the Rolled Mudguards
facing you.
Note:
The orientation of the Guards MUST
be as shown, this will position the
LED Tail Lights in the correct
position.
Remove the Washers and Nuts fitted
to the LED Tail Lights (421-000-056)
Fit an LED Tail Light to each
Mudguard Mount as shown.
Refit the Flat Washers, Spring
Washers and Nuts to secure the LED
Tail Lights.
Tighten to secure.
Feed the LED Tail Light Wiring
through the holes shown.
Position the Right-Hand Mudguard
Assembly over the Right-Hand Tyre
on the Snake Chassis as shown.
Note:
See next picture for Bolt Setup detail.
LONG side of
Mudguards
LED Tail Lights in place
LED Tail Light Wiring
through here
Fasteners refitted