Trimax Snake - Install and Torque Castle Nut; Castle Nut Torque and Adjustment Warnings

9
Fit the Washer (308-200-064) over
the Axle thread.
Fit the Castle Nut (416-842-200) onto
the Axle thread.
Torque the Castle Nut to 68Nm
WHILE ROTATING THE HUB.
IMPORTANT:
Do not use an impact gun for this step
or bearing/hub damage may occur.
Back the Castle Nut off one full turn.
Re-torque the Castle Nut back up to
14Nm WHILE ROTATING THE
HUB.
IMPORTANT:
Back the Castle Nut off 1/6 to 1/4 of
a turn until the hole for the split pin
is aligned.
Ensure the hub turns freely without
sideways play.