Trimble EZ-Guide 500 - Connecting the Lightbar Only

CHAPTER
1
EZ-Guide 500 System Cabling Guide 7
Connecting the Lightbar Only 1
In this chapter:
 EZ-Guide 500 lightbar only
The EZ-Guide
®
500 lightbar guidance system can
operate as a standalone guidance system, or you
can connect it to a range of agricultural guidance
devices to expand its functionality. This
document shows you how to complete those
cable connections.
To connect:
• the lightbar as a standalone guidance
system, see Chapter 1.
• the lightbar to the EZ-Boom
™
2010
automated application control system, see
Chapter 2.
• the lightbar to a Field-IQ system, see
Chapter 3.
• the lightbar to the EZ-Steer
®
500 system,
see Chapter 4.
• the lightbar to the AgGPS
®
Autopilot
™
assisted steering system, see Chapter 5.
• the lightbar to a factory-ready guidance
system, see Chapter 6.
• the lightbar to a serial variable rate
controller, see Chapter 7.
• the lightbar to a coverage switch or radar
cable, see Chapter 8.