9 Data Transfer
112 Trimble M3 Total Station User Guide
• To upload a point number/name list to the
instrument, press
[3] Upload Point List.
See Uploading a point name/number list from
the office computer, page 114.
• To upload a point code list to the instrument,
press
[4] Upload Code List. See Uploading a
point code list from the office computer,
page 114.
9.8 Transferring recorded data to the office computer
1. Press [1] MEM-Periph. in the DATA
TRANSFER menu to open the MEM-Periph
screen. The job that is currently open, and the
start and end address for downloading appears.
2. Do one of the following:
– To open the job list, press
[F1] Job.
–To go to the
Setting Interface
screen, press
[F2] Int. Use [<] or [>] to change
settings or input a new value.
– To search for or define an address, press
[F3]
Search. You can search the point by point
name, point code, or address. Press
[F4]
o.k.to download data.
– To start downloading data to the office
computer, press
[F4] o.k.
To stop the process, press [ESC]. The number
of lines that have already been transmitted
appear on screen.
To Next Page
Loading...