Trimble M3 Total Station - Measurement intervals; Angle measurement; Dual-axis tilt sensor; Clamps;tangent screws

Trimble M3 Total Station User Guide 139
Data Formats B
Point to line
(Station +
Offset)
x x STA+OFF
point to line
x A PPPPPPPPPPPP SD Hz Vk
reference point A
x B PPPPPPPPPPPP SD Hz Vk
reference point B
x A=S
if station is defined as A
x B=S
if station is defined as B
x A-B SD HD h
base length
x CCCCC PPPPPPPPPPPP SD Hz Vk
meas. pt. P
x CCCCC PPPPPPPPPPPP y x h/Z/ω
meas. pt. P; y, x, e, n depending
on the coordinate system if
station is defined as P
x P=S Y X h/Z/ω
Connect.
distance
x CON. DST.
x A PPPPPPPPPPPP SD Hz Vk
reference point A
x CCCCC PPPPPPPPPPPP SD Hz Vk
meas. pt. P
x A-P SD HD h/Z
connecting distance A-P
x P-P SD HD h/Z
connecting distance P-P
Object height x x OBJ. HT
x A PPPPPPPPPPPP SD Hz Vk
reference point A
x CCCCC PPPPPPPPPPPP Hz Vk
meas. pt. P, k=1...4, depending
on V system
x CCCCC PPPPPPPPPPPP HD O Z
meas. pt. P
x ! PPPPPPPPPPPP Z
Set Z value
x PPPPPPPPPPPP Hz Vk
k=1, 2, 3, 4 depending on V
system
Vertical
plane
x x VERT. PL
x A PPPPPPPPPPPP SD Hz Vk
reference point A
x B PPPPPPPPPPPP SD Hz Vk
reference point B
x A-B SD HD h
base length
x CCCCC PPPPPPPPPPPP Hz Vk
meas. pt. P, k=1...4, depending
on V system
x CCCCC PPPPPPPPPPPP y x h
meas. pt. P; y, x, e, n depending
on the coordinate system
x P=S
if station is defined as P
x x ! PPPPPPPPPPPP y
set value for y, x, or n
depending on the coordinate
system
x x ! PPPPPPPPPPPP h
set value for h
x PPPPPPPPPPPP Hz Vk
xYXh
Table B.7 Recording data lines (continued)
Mode Rec
1
Mode
2
Content of record
P, C , I
T1 T2 T3
Comments