Trimble M3 Total Station User Manual

7 Coordinates
84 Trimble M3 Total Station User Guide
72.3 Confirming the instrument height and Station-Z coordinates
This screen enables you to confirm the instrument
height and station coordinates.
Do one of the following:
• To terminate the program, press [F1] No.
• To input the instrument height and station
coordinates, press
[F3] ih/Zs,
• To accept the instrument height and station Z
coordinates and proceed to the Topo
observation screen, press
[F4] Yes.
72.4 Sighting new points in the Topo observation screen
This screen enables you to sight new points.
1. Sight new points and press
[MEAS/ENT].
2. Do one of the following:
– To take a tracking measurement, hold press
[MEAS/ENT] down for one second.
–To access the
HOT MENU, press the key
from any Topo observation screen.
– To go to the eccentric measurement screen,
press
[F1] ECC, see Eccentric measurement,
page 85
– To activate the INTS program press
[F2]
INTS, see Measuring edges and corners
using the Intersection program (INTS),
page 63.
– To run the Adjustment C&I program press
[F3] CHCK, see Checking and adjusting the
compensator (C) and index (I), page 119.
– To change the screen to show the job name,
point number, code, height of target and
recording mode, press
[F4] 2.

Trimble M3 Total Station Specifications

General

Brand	Trimble
Model	M3 Total Station
Category	Measuring Instruments
Language	English