Trimble R10 - External OmniSTAR Data; Internal OmniSTAR Demodulator; L-Band Beam Status

TrimbleR10ReceiverWebHelp
 G2Only–OmniSTARG2mode.
 HP+XP–OmniSTARHPandXPmode.
 HPOnly–OmniSTARHPonlymode.
 XPOnly–OmniSTARXPonlymode.
 VBSOnly–OmniSTARVBSonlymode.
InternalHP/XPLinkID–TheconfiguredHP/XP
satelliteIDusedbytheinternaldemodulator.
InternalHP/XPLinkName–TheconfiguredHP/XPsatellitenameusedbytheinternal
demodulator.
InternalVBSSatelliteLinkID–TheconfiguredVBSsatelliteIDusedbytheinternaldemodulator.
InternalVBSSatelliteLinkName–TheconfiguredVBSsatellitenameused
bytheinternal
demodulator.
CustomFrequency[MHz]–ManuallyenteredOmniSTARsignalfrequencystoredforCustommode.
CustomBitRate[Hz]–ManuallyenteredOmniSTARbitratestoredforCustommode.
L‐BandBeamStatus
Providesinformationrelatingtothecurrently‐trackedOmniSTARsignal(spotbeam).
SignalSou rce
 Demodulator–
ThereceiverisusingtheOmniSTARdatafromtheinternaldemodulator.
 External–ThereceiverisusingtheOmniSTARdatafromanexternalsourcethroughaserial,
Ethernet,orNTRIPport.
 Off–OmniSTARdataisnotbeingused.
TrackingMode
 Off–OmniSTARsignaltrackingis
off.
 Search–Initializing–SearchingforOmnistarsatellite,initializing.
 Searching–SearchingforOmnistarsatellite,running.
 Track–Initializing–FoundOmnistarsatellite,trackinginitialization.
 FullTracking–FoundOmnistarsatellite,verifyingdatastream.
 FullTracking(Service)–FullytrackingOmnistarsatelliteandusingthe
serviceindicatedinthe
brackets.
SatelliteLinkID–IDoftheOmniSTARsatellitelink.
SatelliteLinkName–NameoftheOmniSTARsatellitelink.
Frequency[MHz]–FrequencyoftheOmniSTARsignal.
BitRate– BitrateoftheOmniSTARsignal.
Eb/No[dB]–Signalstrength.
C/No[dBHz]–Signal
‐to‐Noiseratio(SNR)ofOmniSTARsignal.