INSTALLATION INSTRUCTIONS – On Wire Rack
With a Phillips screwdriver, secure the SLIDES (B) & (C) to the wire
shelf by putting PLATE SCREWS (E) through the slots and fasten to
the RACK PLATES (D).
D (4) E (4)
STEP 3
Attach the WIRE DRAWER (A) to the clips in the LEFT and RIGHT SLIDES (B) & (C) until it
clicks into the clip.
Installation Suggestion: With the WIRE DRAWER (A) resting on top of the CLIPS, brace the
top of the WIRE DRAWER (A) with one hand and, with a rubber mallet, lightly tap each bottom
corner of the CLIPS to secure the WIRE DRAWER (A) into the CLIPS.
STEP 4
To Next Page
Loading...