22
ST2 PRO
As you can see, the calibrated column now says Yes in green. But, on top of the page, the
mention NOT READY is displayed in orange.
To finish the optimization process, you have to “Compute” the Optimization function. Simply hit
the “Compute” button at the bottom of the screen in order to process.
At the top of the screen, you will see this gear icon flashing.
This indicates that the computer is going through the process of creating Optimization filters
based on this measurement.
Once done, it is finally time to listen to the results with the Optimization filters in place.
2 things to remember:
• After you compute a new Optimization, all speakers are muted. Before unmuting,
make sure your microphone is turned OFF (red LED OFF)
• If you are using an external monitor controller, you can go back to unity gain on the ST2 Pro.
To Next Page
