Quick start
23
6 | POST-CALIBRATION
Make sure to disconnect all four analog inputs from the 3D microphone and
reconnect the left and right outputs of your external monitor controller (if any),
so you can start listening to some reference material.
Now, it is time to save all your settings and measurements.
First go to the Presets page and hit the save button on one of the available slots. This way, if
the ST2 Pro is powered down, the preset you just created will be stored in its memory.
You can add a name to your preset before saving it. If you don’t have a keyboard, you can
select the virtual keyboard on the screen’s right and enter the name this way.
We advise you to start listening to recordings that you are very familiar with, like any reference
album or record that is part of your reference process.
Avoid listening to any of your own mixes at first in order to ensure objective, critical listening.
While listening, go to the “Runtime” tab on the interface of the ST2 Pro and turn the Optimization
filters Off. This way, you can return to an entirely bypassed situation and listen without any
Trinnov processing.
Turn the Optimization filters back On to hear what the ST2 Pro is doing.
You are now all set!
You can also watch our Pro-Audio tutorials on our YouTube Channel.
In this series of videos, we guide you on screen through all the essential steps to first set up
an ST2 Pro.
Use the link provided herewith a QR Code to go directly to it.
To Next Page
