TRIOMED UNIVERSAL. USER MANUAL18
When the radiator is attached to the power unit
through the USB cable (Fig 5), the device is switched
on automatically and the indicator shows the num-
ber of the programme (Fig 6) of the attached
radiator (001 for radiator 1 and 005 for radiator 5).
Upon pressing the control button the radiation is
switched on and the indicator shows the duration of the
session in seconds. The countdown will begin, the beeper
located on the power unit will produce sound and the LED
is periodically on and o on the radiator.
If the control button is not pressed within 10 seconds
after the radiator has been attached, the device enters the
standby mode and the indicator is switched o. To switch
the device on, press the control button. The indicator will
show the number of the programme of the radiator at-
tached. To switch radiation on, press the control button
again. The countdown begins, the beeper will produce
sound and the LED will be switched on the radiator.
At the end of the session the indicator will show three
zeros (000). If the control button is not pressed again within
10 seconds, the device will be switched o automatically
and the numbers on the indicator will be turned o.
You can switch o radiation any time during the ses-
sion by pressing the control button. The programme
will be stopped.
To Next Page
Loading...
