Page 12
3.0 PREPARATION FOR USE
3.1 Before using the Test Set, familiarize yourself with the
instrument and this manual. READ AND REVIEW THIS MANUAL
FREQUENTLY.
3.2 Each time the Test Set is used, check, and if necessary,
correct the mechanical zero of the meter. Refer to Section 3.3.
Inspect the Test Set for mechanical defects as described in Section
3.4. Also, inspect the test leads as described in Section 3.5. Finally,
perform the Battery and Fuse Test as described in Section 3.6. Only
after all tests have been passed should the Test Set be used. DO
NOT USE THE TEST SET IF ANY OF THESE TESTS FAIL.
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
