4
1. Disassemble VESA Plate
2a. Mount on Wood Stud Wall
1
3
Find and mark the
exact location of
mounting holes
Screw the wall
mount onto
the wall
Drill pilot holes
WARNING
• Make sure that mounting screws are anchored into the center of the studs.
Use of a stud finder is highly recommended.
• Installers are responsible to provide hardware for other types of mounting situations.
• Installers must verify that the supporting surface will safely support the combined
load of the equipment and all attached hardware and components.
2
Anchor Bolt
5mm-8mm
Maintain a 5mm-8mm
space between the wall
plate and anchor bolt.
Loosen the top screw with a
screwdriver to separate the VESA
plate from the wall mount.
14-03-251-933335.indb 4 4/14/2014 1:59:26 PM
To Next Page
Loading...
