To Next PageTo Next Page
Need help?Do you have a question about the Tripp Lite SmartPro SMART1500RM2U and is the answer not in the manual?
General| Type | Line-Interactive |
|---|---|
| Capacity | 1500VA / 900W |
| Wattage | 900W |
| Input Voltage | 120V |
| Input Frequency | 50 / 60 Hz |
| Output Voltage | 120V |
| Output Voltage Regulation (Line Mode) | +/- 5% |
| Output Voltage Regulation (Battery Mode) | +/- 5% |
| Form Factor | 2U Rackmount |
| Audible Alarm | Yes |
| Output Connections | 8 NEMA 5-15R outlets |
| Battery Type | Sealed Lead-Acid (SLA) |
| Typical Recharge Time | 8 hours |
| Communication Interface | USB, Serial |
Warnings about placing the UPS in suitable indoor locations for proper ventilation and temperature.
Warnings about connecting the UPS to grounded outlets, generators, and circuit protection.
Warnings about using the UPS in life support and connecting surge protectors to the UPS output.
Precautions for handling batteries, replacement procedures, and not operating without batteries.
Warnings about connecting external battery packs and compatibility.
Information on recycling UPS products and lead-acid batteries.
Step-by-step instructions for mounting the UPS in a 4-post rack using included hardware.
Requirements for 2-post rack mounting and wall mounting using kits.
Instructions for mounting the UPS in an upright (tower) orientation.
Connect the UPS to a properly grounded AC power outlet for charging.
Connect electronic equipment to UPS outlets, considering VA ratings to avoid overload.
Procedure to power on the UPS unit and initial startup notes.
Connecting the UPS to a computer via USB or serial for monitoring and control.
Connecting the UPS EPO port to an emergency power off circuit for shutdown.
Connecting Tripp Lite external battery packs to extend UPS runtime.
Overview of the LCD screen, its icons, and the main control buttons (ON/OFF, MODE, MUTE).
Detailed explanation of various icons like Battery, AC Input, Warning, Load, Test, Runtime, and AVR.
How to use the MODE button to view power conditions like voltage, load, runtime, and battery capacity.
Configuring alarm settings, LCD brightness, self-test, and scroll control.
Viewing ON Battery/AVR events and adjusting power sensitivity settings.
Configuring external battery settings and restoring factory defaults.
Description of AC outlets, communication ports, EPO, accessory slot, external battery connector, input breaker, and ground screw.
Procedures for storing the UPS, including battery recharging if stored long-term.
Steps for troubleshooting, contacting support, and returning products for service (RMA).
Step-by-step guide for replacing the UPS batteries.
Compliance statement regarding FCC rules for Class A digital devices.
Information on unique series numbers for product identification and compliance.
Explanation of AC and DC voltage symbols used on product labels.
