What to do if my Tripp Lite SmartPro SMART1500RM2UL UPS shows a Non-Critical Battery Protection Fault?
If your Tripp Lite UPS displays a Non-Critical Battery Protection Fault, it's likely due to the battery experiencing extreme conditions like overcurrent or over-temperature. To resolve this, reduce the load on the UPS, allow it to return to room temperature, recharge the battery for 24 hours, and then restart the UPS if needed.
What to do if my Tripp Lite UPS shows a Charger Fault?
If your Tripp Lite UPS indicates a Charger Fault, it could be because the charge current exceeded its tolerance for more than 10 seconds, or the battery voltage hasn't reached the level needed to start the UPS. Make sure the battery has been charging for 24 hours. Then, restart the UPS or reset the fault by pressing 'Enter/Mute' to return to normal operation.
What to do if my Tripp Lite UPS is showing a Critical Battery Protection Fault?
If your Tripp Lite UPS is showing a Critical Battery Protection Fault, it indicates a component malfunction. Turn off the UPS and contact Tripp Lite for assistance, as this condition requires attention from qualified Tripp Lite technicians.
General| Form Factor | Rackmount |
|---|---|
| Input Voltage | 120V |
| Output Voltage | 120V |
| Number of Outlets | 8 |
| Interface Ports | DB9 Serial, USB |
| Input Plug Type | NEMA 5-15P |
| Frequency | 50 / 60 Hz |
| Waveform Type | Sine Wave |
| Transfer Time | 2-4 ms |
| Typical Recharge Time | 8 hours |
| Power Capacity | 1500 VA |
| Battery Type | Sealed Lead Acid (SLA) |
| Operating Temperature | 32 to 104 degrees F (0 to 40 degrees C) |
| Operating Humidity | 0% to 95% (non-condensing) |
| Safety Approvals | cUL, UL |
To Next Page