Tripp Lite SRXCOOL33K

Other manuals for Tripp Lite SRXCOOL33K

Installation Manual32 pages

Features & Specifications3 pages

Questions and Answers

J
Jerry YoungAug 8, 2025
What to do if there is water around Tripp Lite SRXCOOL33K?
- A
  Andrew KirkAug 8, 2025
  If you find water around your Tripp Lite Air Conditioner, here are a few things to check: * Make sure the condensate drain hose is properly connected and routed to the pump and outside the cooling unit. * Look for and repair any leaks in the drain system. * Adjust the cooling unit's leveling feet to ensure it's properly leveled. * Inspect the piping insulation for damage and repair as needed.
A
allisonkennedyAug 14, 2025
What to do if Tripp Lite Air Conditioner has excess water in or around it?
- L
  lori27Aug 14, 2025
  If you notice excess water in or around your Tripp Lite Air Conditioner, it could be due to a few reasons: * High room humidity. In this case, add a drain line, adjust the set point on humidifying equipment, and improve room sealing. * A dirty filter. Try cleaning the filter. * A dirty coil. Make sure to clean the coil.
R
randy70Aug 18, 2025
Why Tripp Lite SRXCOOL33K Air Conditioner cannot achieve setpoint?
- N
  nwhiteAug 19, 2025
  Your Tripp Lite Air Conditioner might not be reaching the setpoint due to several reasons: * The filter might be dirty, so try cleaning it. * The coil could be dirty; clean the coil. * The heat load may be too far away; relocate the cooling unit closer to the heat source. * The fan speed may be set too low; adjust the fan speed to Auto or increase it.
J
jason34Aug 23, 2025
Why is my Tripp Lite SRXCOOL33K noise level excessive?
- E
  Elijah ChapmanAug 25, 2025
  If your Tripp Lite Air Conditioner is making too much noise, it might be due to improper fan speed. Try selecting a lower fan speed to reduce the noise.
S
Steven GarnerAug 28, 2025
How to fix a Tripp Lite SRXCOOL33K Air Conditioner fan that fails to start?
- B
  Brandi PriceAug 28, 2025
  If the fan on your Tripp Lite Air Conditioner isn't starting, here are a couple of things to consider: * The cooling unit might have shut down due to an external command. Try disconnecting the communications cable and restarting the unit. * The fan itself might be faulty, in which case you should replace it.
J
Justin WelchSep 2, 2025
What to do if Tripp Lite SRXCOOL33K Air Conditioner operates but LCD panel does not function?
- S
  Shawn RobinsonSep 2, 2025
  If your Tripp Lite Air Conditioner is running but the LCD panel isn't working, the local display might not be properly connected. Verify that the local display cable is correctly connected.

Summary

Safety Instructions

General Safety Precautions

Safety guidelines and warnings for operating and servicing the unit.

Unit Operation

LCD Control Panel Interface

Initial Operation and Temperature Settings

Guide to powering on the unit and setting the initial cooling temperature.

LCD Menu Navigation

Alarms and Status Indicators

Explains the HOME menu display and lists all warning and critical alarm conditions.

Status Menu Details

Setup Menu and Configuration

Guide to accessing and configuring unit settings via the SETUP menu.

Troubleshooting

Common Issues and Solutions

Table detailing common problems, their possible causes, and solutions.

Preventive Maintenance

Monthly Maintenance Checklist

Mechanical and Electrical Checks

Warranty and Registration

Limited Warranty Terms

Details the terms and conditions of the limited warranty provided.

Tripp Lite SRXCOOL33K Specifications

General

Cooling Capacity	33, 000 BTU
Phase	1
Compressor Type	Rotary
Refrigerant Type	R410A
Air Flow	1, 200 CFM
Maximum Operating Relative Humidity	95%
Cooling Capacity (Watts)	9, 700 Watts
Noise Level	58 dB