11User manual
Dehumidifying operation
• Press the “Mode“ button until the “Dehumidify” icon appears.
• The temperature will automatically be selected.
• The fan speed will automatically be selected.
Fan operation
• Press the “Mode“ button till the “Fan“ icon appears.
• Press the “Fan speed” button to adjust airflow speed.
Timer operation
Timer ON setting
• When the air-conditioner is OFF, press the “Timer“ button and select a desired ON time and adjust by
using the Temperature up and Temperature down buttons.
• The ON time can be adjusted to anytime in 0-24 hours.
Timer OFF setting
• When the air-conditioner is ON, press the “Timer“ button and select a desired OFF time and adjust by
using the Temperature up and Temperature down buttons.
• The OFF time can be adjusted to anytime in 0-24 hours.
Swing operation (oscillation mode)
• Press this button to start the oscillation mode, the louver will swing continuously up and down. Press
button again to stop the operation.
Drainage
• After a lengthy operation and before storage, you will need to drain the water that has been collected.
Please prepare a suitable location or tray to collect the water and remove the rubber stop from the
drainage hole at the bottom of the unit. The water will then begin to drain. After this has stopped, you can
insert the drain stop.
Internal Tank Water Full Alarm Function
• The inner water tank in the air-conditioner has one water level safety switch that controls the water level.
When the water level reaches an anticipated height, the water full indicator lamp lights up. Follow
previous steps to drain the water.
Using The Appliance With Climate App
The appliance can be used manually with its built-in controls, remote control or you can use a smart phone
or voice to control it. Before you begin, ensure the Connected at Home app is downloaded. The Connected
at Home app is available on Android and iOS.
Pair your appliance to the Connected at Home app.
• Make sure the appliance is powered.
• Press the Fan button B
y
for about 3 seconds until you hear a beep and the Wi-Fi indicator light is
flashing rapidly.
• Open the Connected at Home app.
• Create an account or if you already have an account, please log in using those details.
• Follow the instructions on the app to connect the appliance.
CLEANING AND MAINTENANCE
• Before cleaning, disconnect the unit from any electric supply outlet.
• First clean the surface with a neutral detergent and wet cloth, and then wipe it with a dry cloth.
• Do not use gasoline or other chemicals to clean the unit.
• Do not wash the unit directly.
To Next Page
Loading...
