EasyManua.ls Logo

TriStar PD-3821 - Eu Declaration of Conformity; Troubleshooting

TriStar PD-3821
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12Tristar Europe B.V. | Air Conditioner | PD-3821
Air lter
The air filter should be cleaned once every two weeks.
Open the air inlet grille and take off air filter.
Clean the air filter with neutral detergent in lukewarm 40°C water and allow to dry (not in direct sunlight).
Re-install the air filter into the inlet grille.
EU DECLARATION OF CONFORMITY
Hereby, Smartwares Europe declares that the radio equipment type PD-3821 are in compliance with
Directive 2014/53/EU
The full text of the EU declaration of conformity is available at the following internet address: www.tristar.eu/
doc
TROUBLESHOOTING
Problem Possible cause Possible solution
The unit does not start when
pressing power button.
Water full indicator lamp blinks
and water tank is full.
Drain the water out of the water
tank.
Room temperature is higher than
the setting temperature. (Electric
heating mode)
Adjust the temperature.
Room temperature is lower that
the setting temperature. (Cooling
mode)
The unit doesn’t cool enough. The doors or windows are not
closed.
Make sure all the windows and
doors are closed.
There are heat sources inside
the room.
Remove the heat sources if
possible.
Hot air exhaust hose is not
connected or blocked.
Connect or clean the hot air
exhaust hose.
Temperature setting is too high. Reset the temperature.
Air inlet in blocked. Clean the air inlet.
Noisy. Thegroundisnotlevelornotat
enough.
Placeunitonaat,levelground
if possible.
The sound comes from the
owingoftherefrigerantinside
the air conditioner.
E0 Code Room temperature sensor failed. Replace room temperature
sensor.
E1 Code Condenser temperature sensor
failed.
Replace condenser temperature
sensor.
E2 Code Water tray full when cooling. Takeo󰀨rubberstopperandempty
the watertank.
E3 Code Pipe temperature sensor failed. Replace pipe temperature sensor.
E4 Code Water tank full. Please empty the water tank.
DISPOSAL
The crossed out wheelie bin symbol means that this product shall not be disposed of with normal
household waste. Electronic and Electrical Equipment not included in the selective sorting
process are potentially dangerous for the environment and human health due to the presence of
hazardous substances. Please dispose of responsibly at an approved waste or recycling facility.

Related product manuals