Tritton SEE2 - Troubleshooting

T ROUBLESHOOTING T IPS
The following troubleshooting tips may help if you are experiencing any difficulties using
your Tritton SEE2. Contact your dealer for additional assistance if needed.
- Check to make sure that all connectors are plugged in properly.
- Reset/refresh/resynchronize your monitor.
- Make sure that the USB port that you are using is USB 2.0.
- Try connecting the SEE2 directly to the computer instead of through a hub.
- Try a different USB 2.0 port and/or computer
- Check to see that the monitor is connected correctly and the power is ON.
- Try Unplugging all other USB devices from the system.
- Make sure to restart your computer after the driver installation.
- Unplug the SEE2, wait a few seconds, and re-connect.
- Check the website to make sure you have the latest drivers.
- Selecting Primary Mode may disable the main system display on certain Intel graphics
solution based computer systems that will not allow primary to shift to another device.
- If you have problems during the boot up process, start your computer in Safe Mode
and uninstall the driver. Hold the CTRL key until the Windows startup menu appears
and select Safe Mode.
Copyright© 2008 Tritton Technologies Inc. All rights reserved. All trade names are registered trademarks
of their respective owners. Features and specifications are subject to change without notice. Product may
not be exactly as shown in the diagrams
8