Triumph AL7100F - Page 8

8
For Customer Service Call 1-888-996-2729
© 2019 Escalade Sports
All RIghts Reserved.
STEP 4
PARTS REQUIRED:
2 pcs - H2 M6 x 90 mm Allen Head Bolt 2 pcs - H6 Plastic Bushing
2 pcs - H4 Flat Washer 1 pc - P5 Front Tube Assembly
2 pcs - H5 Wing Nut 2 pcs - P15 Locking Pin
Connect P5 Front Tube Assembly using Spring Lock
as shown in FIGURE 4.
NOTE: Bungee Cord is an assembly aide and stays in place.
FIGURE 4
Spring Lock
Bungee
Cord
Spring Lock
Bungee
Cord
STEP 5
Connect P5 Front Tube Assembly to P1 - Left Lower Tube Assembly
and P2 - Right Lower Tube Assembly using H2 Bolts, H4 Washers,
H6 Bushing and H5 Wing Nuts as shown in FIGURE 5 and DETAIL B.
Note: This is a pivot point. “Snug” tighten H5 Wing Nuts only.
Make sure this assembly pivots freely.
P5
P5
P2
P1
P5
P1
H2
H4
H5
P15
H6
FIGURE 5
DETAIL B
NOTE: Use “bottom” hole
for this assembly.
NOTE: Push H2 Bolts
around the inner bungee
cord.