1104
7. Fill the master cylinder with new, DOT 4 brake fluid from a sealed container.
8. Bleed the rear brake caliper (see Bleeding the Rear Brake).
9. Pump the brake pedal to correctly position the caliper pistons.
10. Tighten the rear caliper bolts to 45 Nm.
Use only DOT 4 specification brake fluid as listed in the general information section of
this manual. The use of brake fluids other than those DOT 4 fluids listed in the general
information section may reduce the efficiency of the braking system leading to loss of
motorcycle control and an accident.
Observe the brake fluid handling warnings given earlier in this section of the manual.
11. Check for correct brake operation.
It is dangerous to operate the motorcycle with defective brakes; you must have your
authorised Triumph dealer take remedial action before you ride the motorcycle again.
Failure to take remedial action may result in reduced braking efficiency leading to loss
of motorcycle control and an accident.
Perform the following operations:
• Rear Wheel - Installation
To Next Page
Loading...
