Triumph Rocket 3 GT 2021 - Page 1157

1119
6. Attach the wheel speed sensor conduit to the harness fit a new fixing and tighten to
9 Nm.
1. Fixing
2. Harness
3. Conduit
Perform the following operations:
• Fuel Tank - Installation
• Battery - Installation
• Seat - Installation
Front ABS Pulser Ring – Removal
Before starting work, make sure the motorcycle is stabilised and adequately
supported. This will help prevent it from falling and causing injury to the operator or
damage to the motorcycle.
NOTICE
The front ABS pulser ring is mounted on the front left hand brake disc.
1. Remove front brake disc and pulser ring (see Front Brake Disc - Removal).