795
6. Fit and fixings and tighten, upper one first, to 2.5 Nm.
Perform the following operations:
• Mirrors - Installation
• Battery - Installation
• Seat - Installation
Move the handlebars to left and right full lock while checking that the brake hose,
clutch hose and electrical harnesses do not bind or that the steering feels tight or
difficult to turn. A hose, cable or harness that binds, or steering that is tight/difficult to
turn will restrict the steering and may cause loss of control and an accident.
Check for correct operation of the front brake, clutch and twist grip. Check that the
brake hose, clutch hose and electrical harnesses do not bind or restrict the steering
when the handlebars are turned from lock-to-lock. Rectify as necessary.
Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
To Next Page
Loading...
