Make sure the motorcycle is stabilised and adequately supported.
A correctly supported motorcycle will help prevent it from falling.
An unstable motorcycle may fall, causing injury to the operator or damage to the
motorcycle.
1. Fit a new sealing washer to the coolant temperature sensor and fit to the cylinder
head.
1. Coolant temperature sensor
2. Sealing washer
3. Thermostat housing
2. Using a suitable 19 mm slotted socket, tighten temperature sensor to 18 Nm.
3. Route the wiring as noted for removal and reconnect the sensor to the main harness.
Perform the following operations:
• Radiator - Installation
• Battery - Installation
• Seat - Installation
To Next Page
Loading...
