15
5.Basic Operation
Operation Flow
1. ¤ Mount the syringe pump on the IV Pole or Cage
2. ¤ Power on: press two seconds
3. ¤Install syringe
4. ¤ Confirm syringe brand and size: or select syringe brand
5. ¤Remove air bubble in the line
6. ¤Select infusion mode: select infusion modes according to requirement
7. ¤Set infusion Parameters: set infusion parameters according to requirement
8. ¤ Connect infusion line with patient
9. Confirm all Settings and Parameters
10. ¤ Start infusion: press
11. ¤ Infusion finish
12. ¤ Remove syringe
13. ¤ Power off or Standby
To Next Page
Loading...