EasyManuals Logo

Triumph Speed Twin 1200 User Manual

Triumph Speed Twin 1200
198 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #80 background imageLoading...
Page #80 background image
HOW TO RIDE THE MOTORCYCLE
80
To start the engine:
Check that the engine stop switch is
in the RUN position.
Make sure the transmission is in
neutral.
Turn the ignition switch on.
Note
When the ignition is switched on, the
instrument warning lights will illuminate
and will then go off (except those which
normally remain on until the engine
starts, see the Warning Lights section).
Pull the clutch lever fully into the
handlebar.
Leaving the throttle fully closed,
push the starter button until the
engine starts.
The motorcycle is equipped with
starter lockout switches. The
switches prevent the electric
starter from operating when the
transmission is not in neutral with
the side stand down.
If the side stand is extended while
the engine is running, and the
transmission is not in neutral then
the engine will stop regardless of
the clutch lever position.
Moving Off
To move the motorcycle:
Pull in the clutch lever and select
first gear.
Open the throttle a little and let out
the clutch lever slowly.
As the clutch starts to engage, open
the throttle a little more, allowing
enough engine speed to avoid
stalling.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Triumph Speed Twin 1200 and is the answer not in the manual?

Triumph Speed Twin 1200 Specifications

General IconGeneral
Displacement1200 cc
Bore x Stroke97.6 mm x 80 mm
Compression Ratio12.1:1
Fuel SystemMultipoint sequential electronic fuel injection
ClutchWet, multi-plate assist clutch
Gearbox6-speed
Front WheelCast aluminum alloy, 17 x 3.5 in
Rear WheelCast aluminum alloy, 17 x 5.0 in
Front Tire120/70 ZR17
Rear Tire160/60 ZR17
Engine TypeLiquid-cooled, 8-valve, SOHC, 270° crank angle parallel twin
Max Power98.6 HP (73.5 kW) @ 7, 250 rpm
Max Torque112 Nm @ 4, 250 rpm
ExhaustStainless steel 2-into-2 exhaust system with twin silencers
Final DriveChain
FrameTubular steel
Front Suspension120mm travel
Rear SuspensionTwin shocks, adjustable preload, 120mm rear wheel travel
Front BrakesBrembo 4-piston calipers, 320mm discs, ABS
Rear BrakesNissin 2-piston caliper, 220mm disc, ABS
Seat Height809 mm
Fuel Tank Capacity14.5 liters
Dry Weight216kg (476lb)

Related product manuals