BODY
6.
DRIP
CHANNELS-TO
FIT
(See
Figs.
5
and
6)
Fig.
7
Fitting Rear Window and Waist Rubber.
Fig.
5
Fitting lower part of Drip Channel.
After correctly shaping the ends of the
drip channels, position the channels and
draught rubbers
"
C
"
on the "Hard Top
"
as dustrated and secure with the screws
"
A
"
and
"
B
".
(Fig.
6.)
Fig.
8
Fitting Screen Rubber.
Fig.
6
Fitting Drip Channel and Draught Rubber.
7.
SEALING RUBBERS-TO
FIT
8.
HARD
TOP-TO
FIT
Using
"
Seelastik
",
secure the rubber
Re-position the
cc
Hard Top
"
on the
bod
mould
"
D
"
(Fig.
7)
to the rear lower
and after loosely assembling the attack
edge, and the rubber section
"
E
"
(Fig.
8)
ment bolts, progressively tighten them
unt
to
the front top edge of the
c‘
Hard Top
".
the
"Top
"
is
finally secured.
6
To Next Page
Loading...
