MAINTENANCE
(5) Check/top up windscreen washer fluid level
I.
Check fluid level
in
translucent reservoir.
If
topping up
is
necessary:-
2.
Wipe
clean the reservoir cap and surrounding area.
3. Remove the reservoir cap.
4. Add soft water to bring level up to approximately
in
(25-4 mm) from top
of
reservoir.
5.
Replace reservoir cap.
CAUTION:
As
a precaution against freezing conditions, fill
the reservoir with a mixture
of
one part methylated
spirits and two parts water.
Do
NOT use glycol anti-freeze solutions in the washer
reservoir,
as
these may discolour paintwork and
damage wiper blades and sealing rubbers.
(6) Check/top up battery
NOTE: Alternative procedures are given for each
of
the two
battery types that may be fitted.
I.
Lift and tilt battery cover.
2. Check electrolyte level, which
if
correct should
just
cover the separators.
If
topping up
is
necessary:-
3. Add DISTILLED WATER until the filler tubes are
full and the trough
is
just covered.
4. Replace battery cover.
Alternatively:.
I.
Remove
battery
filler plugs.
2. Check electrolyte level, which
if
correct should just
cover the separators.
If
topping up
is
necessary:-
3. Add DISTILLED WATER until the separators are
just covered.
DO
NOT OVERFILL.
4. Replace filler plugs.
CAUTION: Paintwork can be damaged by direct contact
with the
base
of
filler plugs.
10.00.06
1
Triumph
TR6
Manuu1. PUff
No.
545277
Issue
1
To Next Page
Loading...
