MAINTENANCE
(56) Inspect brake pads for wear and discs for condition
Front brakes
I. Jack up front
of
car and place safely on stands.
2. Remove front brake pads
~
See 70.40.02
CAUTION: Do NOT depress the brake pedal while
pads are removed.
3. Report pad condition
if
the friction lining has been
reduced to 0·125 inch (3 mm) or
if
there
is
not
sufficient material to provide a thickness
of
0·125
in
(3 mm) at the completion
of
a further 3,000 miles
(5,000km)
motoring.
4. Check brake discs for excessive scoring and report
this
if
present.
5. Check brake discs for run out and report this
if
it
exceeds 0·007 in (0·178 mm).
6. Refit front brake pads - See 70.40.02
7. Lower car
off
stands.
(57) Inspect and report brake linings for wear and drums
for condition
I.
Jack up car and place safely on stands.
2. Remove road wheel - See 74.20.01.
3. Remove brake drum - See 70.10.02 (front) or
70.10.03 (rear).
4. Check brake linings for wear and report
if
linings are
excessively worn.
5. Check brake linings for damage and contamination by
oil or
gn::ase
and report
if
linings are damaged or
contaminated.
6. Check brake drums for wear, scoring or other damage
and report if drums are excessively worn, scored or
damaged.
7. Remove dust, oil and grease from brake drum and
backplate.
8. Retit brake drum - See 70.10.02 (front) or 70.10.03
(rear).
9. Refit road wheel - See 74.20.01.
10. Lower car
off
stands.
10.00.20
~
2
.....•
~
0,
,
3
MT,271'
Triumph
TR6
Manual. Part
No
. .545277 Issue 1
MT2719
To Next Page
Loading...
