Trojan HYDROLINK SNAKE - Step 1: Remove Vent Caps and Insert Vents; Step 2: Press HydroLink Vents Down; Step 3: Install Snake Tubing

To Next Page

To Previous Page

HYDROLINK™ WATERING SYSTEM WITH SNAKE™ TUBING

INSTALLING A HYDROLINK WATERING SYSTEM ON YOUR TROJAN BATTERIES

IMPORTANT: Make sure to follow instructions on Page 5 before installing.

STEP 1 - REMOVE CURRENT VENT CAPS AND

INSERT HYDROLINK VENTS.

STEP 2 - FIRMLY PRESS HYDROLINK

VENTS DOWN.

Ensure HydroLink vents are completely seated

to avoid electrolyte spillage.

WARNING! PRESS ON THE HYDROLINK

VENT WITH YOUR HANDS ONLY -

DO NOT USE A HAMMER.

STEP 3 - INSTALL SNAKE TUBING

Review the diagrams on

www.trojanbattery.com/pdf/TRJN_

InstallationDiagram.pdf for proper Snake tube

routing based on the application and manufacturer.

Once reviewed, remove the center plastic plug off

the HydroLink vent.

Then snap each Snake plug into each HydroLink

vent. Press ﬁrmly until your hear a click.

(continue on pg 8)