Trojan HYDROLINK SNAKE - HydroLink Installation; Step 1: Install Snake Tubing

To Next Page

To Previous Page

TROJAN BATTERY

6 HYDROLINK INSTALLATION

IF PRE-INSTALLED ON YOUR TROJAN BATTERIES

If you purchased your Trojan batteries pre-installed with HydroLink vents, then you have one simple step below:

STEP 1 - INSTALL SNAKE TUBING

Review the diagrams on www.trojanbattery.com/pdf/TRJN_InstallationDiagram.pdf for proper Snake tube routing

based on the application and manufacturer. Once reviewed, remove the center plastic plug from the HydroLink vent.

Snap each Snake plug into each HydroLink vent. Press ﬁrmly until your hear a click.

If you don’t hear a click, it has not been installed correctly.

YOUR HYDROLINK WATERING SYSTEM IS NOW READY FOR USE.

Correctly Installed

Incorrectly Installed