GB
│
IE
│
7 ■TLGL 1000 B1
NOTE
► Between 1 and 7 batteries can be charged individually:
- 4 x type C or type D batteries in the charging slots 1 to 4
7
, plus 1 x
Li-ion battery (3.6–3.7 V) on the charging contacts
5
or
- 6 x type AA or AAA batteries in the charging slots 1 to 4
7
, plus 1 x
Li-ion battery (3.6–3.7 V) on the charging contacts
5
Charging Ni-MH/Ni-Cd batteries
♦ After you have connected the battery charger to mains power, you can now
insert Ni-MH/Ni-Cd batteries in charging slots 1 to 4
7
and charge them.
♦ The charging process starts automatically as soon as the batteries have
been inserted. The battery charger has an operating status display
2
for
each compartment in the charging slot. The operating status display of the
respective charging slots shows the current charge status of the individual
batteries. The display also shows the current charge level of the batteries
in percent.
NOTE
► If one of the operating status displays flashes red for longer than
5 seconds, the battery is improperly inserted or defective.
Charging Li-ion batteries
♦ After you have connected the battery charger to mains power, you can now
charge a Li-ion battery. Proceed as follows:
♦ Match the charging contacts
5
to the positions of the positive and negative
terminals on your Li-ion battery, by sliding the charging contacts
5
into the
corresponding positions.
♦ Insert the Li-ion battery with its charging contacts lined up with the charging
contacts
5
of the battery charger.
CAUTION
► Ensure that the charging contacts
5
are only in contact in the positive and
negative terminals of your Li-ion battery. The polarity and voltage of the
rechargeable battery catwalk are recognised automatically by the battery
charger. Li-ion often have more than two contacts. Connecting the charging
contacts
5
with the other contacts of your Li-ion battery could destroy your
battery.
To Next Page
Loading...
Need help?
General
