GB
│
IE
│
9 ■TLGL 1000 B1
Timer control
This battery charger has a timer control which automatically switches over to
retention charging after 17 hours. This serves as an additional protection against
overcharging should the charge termination not respond due to a possibly defec-
tive battery.
Charging a USB device
IMPORTANT
► Ensure that the power consumption of the USB device is not higher than
1000 mA. For more information, refer to the instruction manual of your
USB device.
♦ Insert the USB connector of the USB device into the USB output
3
of the
battery charger.
♦ If necessary, switch the USB device on.
NOTICE
► You can simultaneously charge batteries in the battery charger and a USB
device at the USB output
3
. Be aware that the charging current for the batter-
ies is thereby halved and the charging process thus takes somewhat longer.
Cleaning
DANGER
► Always remove the plug before cleaning the device. There is the risk of an
electric shock!.
► When you are cleaning the device ensure that no moisture gets inside it, so
as to avoid irreparable damage to it.
IMPORTANT
► Do not use aggressive or abrasive cleaning agents, as these can damage
the upper surfaces.
Cleaning the housing
♦ Clean the surfaces of the device with a soft, dry cloth. For stubborn soiling
use a lightly moistened cloth.
♦ Never clean the insides of the charging slots with moist cloths. Instead, use
a clean soft brush to clean them.
♦ If soiled, clean the charging contacts with a dry cloth.
To Next Page
Loading...
Need help?
General
