GB/IE/NI 18
In order to charge the power bank, use a power supply
with an output voltage and current matching the rated input
voltage and current as stated in „Technical specifications“ of
this user manual.
A connected device is not being charged.
The battery is drained.
Charge the battery.
The device is not connected.
The device is not connected. Check that it is connected.
Briefly press the ON / OFF button
6
to begin the charging
process.
The current consumption of the connected device might be
too low.
Check with your connected device manual and see if your
connected device current consumption comply with this
product. The minimal output current of the power bank is
approx. 60 mA.
The power bank
3
does not react when the
button is pressed or when a device is connected,
even though the battery is charged.
The power consumption of the connected devices is too
high. Therefore, the internal overcurrent protection device
was activated.
Reduce the number of devices connected and press the
ON / OFF button
6
.
To Next Page
Loading...
Need help?
General
